Skip to content
AnsweredACulvertQ&A #2277502006-03-13 18:05 · Views 59

U-TYPE

U-TYPE 단면 수치입력후 SAP 구동시 해석단면에 오류가 있어 돌아가지 않습니다. 오류 검토 부탁드립니다.

Answer

안녕하세요. 한길아이티입니다. 좌우측 벽체 상부구간이 프로그램 내부적으로 소숫점 넷째자리에서 오류가 있었습니다. Taper구간이 아닌곳에서 Taper처리로 되면서 Sap Data의 Frame Section에 오류가 발생되었습니다. 수정하여 패치에 적용토록 하겠습니다. 감사합니다.

More in this list

StatusProductNo.TitleViewsDate
AnsweredACulvert#268543Pile calculation report3272026-09-28
AnsweredACulvert#268536Setting section changes in culvert1662026-09-28
AnsweredACulvert#268524Design check not performed at wall center2152026-09-27
AnsweredACulvert#268523Applying moving vehicle loads2312026-09-27
AnsweredACulvert#268522Question about pile layout2572026-09-23
AnsweredACulvert#268521Question about features1282026-09-23
AnsweredACulvert#268510Question about joint check in Excel report output1802026-09-22
AnsweredACulvert#268499Error in STM analysis of corner region1392026-09-22
AnsweredACulvert#268471Launching the culvert program592026-09-18
AnsweredACulvert#268442All lines are displayed as dashed lines, what should I do?1372026-09-17
AnsweredACulvert#268429Question about U-type underpass1252026-09-17
AnsweredACulvert#268424Load position when applying railway loads to an underpass2302026-09-17
AnsweredACulvert#268417Changing girder dimensions1462026-09-17
AnsweredACulvert#268396Incorrect section check location for horizontal rebar1732026-09-16
AnsweredACulvert#268376Question about segment settings for U-type retaining wall1852026-09-15
AnsweredACulvert#268343Question about culvert drawing output1262026-09-15
AnsweredACulvert#268337Inquiry about checking retaining-wall-type wing walls3002026-09-14
AnsweredACulvert#268330About drawing output1502026-09-14
AnsweredACulvert#268318Some blocks not displayed1352026-09-14
AnsweredACulvert#268317Tank load for surcharge and moving loads3342026-09-14
Sign in to ask