Skip to content
AnsweredACulvertQ&A #2268572005-10-15 18:47 · Views 36

Question about internal loads

수로암거에서 내부하중(내부수압)값을 넣어서 돌린 결과값과 넣지 않고 돌리 결과값(모멘트)값이 같습니다. 확인부탁드립니다.([개인정보]) 그리고 옹벽식 날개벽에서 철근배근을 하려고하면 에러메세지가 뜹니다. 이것도 확인해 주십시요.([개인정보], 파일명:[개인정보]) 그리고 하중조건에서 지점침하를 고려할 수 있는 옵션이나 방법이 있으면 알려 주셨으면 합니다.

Answer

안녕하세요. 한길아이티입니다. 1. 내부 수압적용 => 내부 수압적용시 오류가 있었습니다.수정후 패치에 적용토록 하겠습니다. 2. 옹벽 배근오류 => 수정하여 패치에 적용토록 하겠습니다. 3. 지점침하 => 지점침하 고려 관련 옵션은 지원하지 않고 있습니다. 감사합니다.

More in this list

StatusProductNo.TitleViewsDate
AnsweredACulvert#268543Pile calculation report3292026-09-28
AnsweredACulvert#268536Setting section changes in culvert1702026-09-28
AnsweredACulvert#268524Design check not performed at wall center2152026-09-27
AnsweredACulvert#268523Applying moving vehicle loads2342026-09-27
AnsweredACulvert#268522Question about pile layout2612026-09-23
AnsweredACulvert#268521Question about features1292026-09-23
AnsweredACulvert#268510Question about joint check in Excel report output1812026-09-22
AnsweredACulvert#268499Error in STM analysis of corner region1422026-09-22
AnsweredACulvert#268471Launching the culvert program592026-09-18
AnsweredACulvert#268442All lines are displayed as dashed lines, what should I do?1382026-09-17
AnsweredACulvert#268429Question about U-type underpass1262026-09-17
AnsweredACulvert#268424Load position when applying railway loads to an underpass2332026-09-17
AnsweredACulvert#268417Changing girder dimensions1472026-09-17
AnsweredACulvert#268396Incorrect section check location for horizontal rebar1772026-09-16
AnsweredACulvert#268376Question about segment settings for U-type retaining wall1882026-09-15
AnsweredACulvert#268343Question about culvert drawing output1282026-09-15
AnsweredACulvert#268337Inquiry about checking retaining-wall-type wing walls3012026-09-14
AnsweredACulvert#268330About drawing output1512026-09-14
AnsweredACulvert#268318Some blocks not displayed1372026-09-14
AnsweredACulvert#268317Tank load for surcharge and moving loads3352026-09-14
Sign in to ask