Skip to content
AnsweredACulvertQ&A #2266062005-09-12 19:11 · Views 52

Calculation report output

계산서 출력은 되는데 출력하는데 약10분 이상의 시간이 소요됩니다. 제 컴 사양은 pentium-4 2.8G입니다. 4%에서 거의 정지상태로 있다가 한 5분이상 지나면 조금씩 진행됩니다. 그리고 지반반력계수가 아래서 말씀드린대로 10배로 나옵니다 계산서 출력시 시간이 오래 걸리는 현상은 저만이 아니고 Aculvert를 까신 다른분도 같은 현상이 일어났다고 합니다. 검토부탁드립니다.

Answer

안녕하세요. 한길아이티입니다. 저희가 계산서를 출력할 경우에는 아무 문제없이 잘 뽑히고 있습니다. 늦게 뽑히는 원인을 파악하는 데로 알려 드리겠습니다. 지반반력계수가 10배로 나오는 것을 확인하였습니다. 수정하여 패치에 반영하겠습니다. 감사합니다.

More in this list

StatusProductNo.TitleViewsDate
AnsweredACulvert#268543Pile calculation report3292026-09-28
AnsweredACulvert#268536Setting section changes in culvert1722026-09-28
AnsweredACulvert#268524Design check not performed at wall center2152026-09-27
AnsweredACulvert#268523Applying moving vehicle loads2352026-09-27
AnsweredACulvert#268522Question about pile layout2612026-09-23
AnsweredACulvert#268521Question about features1302026-09-23
AnsweredACulvert#268510Question about joint check in Excel report output1842026-09-22
AnsweredACulvert#268499Error in STM analysis of corner region1422026-09-22
AnsweredACulvert#268471Launching the culvert program592026-09-18
AnsweredACulvert#268442All lines are displayed as dashed lines, what should I do?1392026-09-17
AnsweredACulvert#268429Question about U-type underpass1262026-09-17
AnsweredACulvert#268424Load position when applying railway loads to an underpass2362026-09-17
AnsweredACulvert#268417Changing girder dimensions1522026-09-17
AnsweredACulvert#268396Incorrect section check location for horizontal rebar1802026-09-16
AnsweredACulvert#268376Question about segment settings for U-type retaining wall1912026-09-15
AnsweredACulvert#268343Question about culvert drawing output1282026-09-15
AnsweredACulvert#268337Inquiry about checking retaining-wall-type wing walls3042026-09-14
AnsweredACulvert#268330About drawing output1522026-09-14
AnsweredACulvert#268318Some blocks not displayed1382026-09-14
AnsweredACulvert#268317Tank load for surcharge and moving loads3372026-09-14
Sign in to ask