Skip to content
AnsweredACulvertQ&A #2265302005-09-06 02:42 · Views 48

Cannot proceed to the next step from other rebar input

검토부탁드립니다 수고하세요

Answer

안녕하세요. 한길아이티입니다. 아래와 같이 진행 하시면 됩니다. 1. "접속슬래브 상세" 메뉴로 이동 하신후 화면표시도면을 평면도로 체크 합니다. 2. 좌측,우측 접속 슬래브 데이터를 확인해보면, L2 = -4000 : 접속 슬래브 길이가 음수입니다. A1 = 0 : 시점부 접속 슬래브와 암거의 각도(0도이면 암거와 평행이 되므로 오류가 발생됩니다) A2 = 0 : 종점부 접속 슬래브와 암거의 각도(시점부와 각도와 같은 개념입니다) 위 3개 평면상의 좌.우측 접속 슬래브 데이터를 수정하신후 "기타철근 입력"메뉴에서 다음버튼으로 이동하시면 됩니다. 감사합니다.

More in this list

StatusProductNo.TitleViewsDate
AnsweredACulvert#268543Pile calculation report3292026-09-28
AnsweredACulvert#268536Setting section changes in culvert1722026-09-28
AnsweredACulvert#268524Design check not performed at wall center2152026-09-27
AnsweredACulvert#268523Applying moving vehicle loads2352026-09-27
AnsweredACulvert#268522Question about pile layout2612026-09-23
AnsweredACulvert#268521Question about features1302026-09-23
AnsweredACulvert#268510Question about joint check in Excel report output1842026-09-22
AnsweredACulvert#268499Error in STM analysis of corner region1422026-09-22
AnsweredACulvert#268471Launching the culvert program592026-09-18
AnsweredACulvert#268442All lines are displayed as dashed lines, what should I do?1392026-09-17
AnsweredACulvert#268429Question about U-type underpass1262026-09-17
AnsweredACulvert#268424Load position when applying railway loads to an underpass2362026-09-17
AnsweredACulvert#268417Changing girder dimensions1522026-09-17
AnsweredACulvert#268396Incorrect section check location for horizontal rebar1802026-09-16
AnsweredACulvert#268376Question about segment settings for U-type retaining wall1912026-09-15
AnsweredACulvert#268343Question about culvert drawing output1282026-09-15
AnsweredACulvert#268337Inquiry about checking retaining-wall-type wing walls3042026-09-14
AnsweredACulvert#268330About drawing output1522026-09-14
AnsweredACulvert#268318Some blocks not displayed1382026-09-14
AnsweredACulvert#268317Tank load for surcharge and moving loads3372026-09-14
Sign in to ask