Skip to content
AnsweredACulvertQ&A #2263622005-07-29 20:43 · Views 50

Cannot change wall distribution rebar

표준단면 입력에서/ 배력철근 설정/ 내측벽체 D13입력/ => 표현,도면 D16 으로 표현됨.

Answer

안녕하세요. 한길아이티입니다. 철근 마크 표현시 오류가 있었습니다.수정하여 15시전에 패치 파일에 적용하도록 하겠습니다. 패치를 실행시키신후 "표준단면 입력 " 메뉴의 "배력철근 설정" 버튼을 클릭후 확인을 눌러주시면 적용됩니다. 감사합니다.

More in this list

StatusProductNo.TitleViewsDate
AnsweredACulvert#268543Pile calculation report3292026-09-28
AnsweredACulvert#268536Setting section changes in culvert1732026-09-28
AnsweredACulvert#268524Design check not performed at wall center2162026-09-27
AnsweredACulvert#268523Applying moving vehicle loads2372026-09-27
AnsweredACulvert#268522Question about pile layout2612026-09-23
AnsweredACulvert#268521Question about features1302026-09-23
AnsweredACulvert#268510Question about joint check in Excel report output1842026-09-22
AnsweredACulvert#268499Error in STM analysis of corner region1432026-09-22
AnsweredACulvert#268471Launching the culvert program592026-09-18
AnsweredACulvert#268442All lines are displayed as dashed lines, what should I do?1392026-09-17
AnsweredACulvert#268429Question about U-type underpass1262026-09-17
AnsweredACulvert#268424Load position when applying railway loads to an underpass2372026-09-17
AnsweredACulvert#268417Changing girder dimensions1522026-09-17
AnsweredACulvert#268396Incorrect section check location for horizontal rebar1832026-09-16
AnsweredACulvert#268376Question about segment settings for U-type retaining wall1912026-09-15
AnsweredACulvert#268343Question about culvert drawing output1282026-09-15
AnsweredACulvert#268337Inquiry about checking retaining-wall-type wing walls3062026-09-14
AnsweredACulvert#268330About drawing output1532026-09-14
AnsweredACulvert#268318Some blocks not displayed1392026-09-14
AnsweredACulvert#268317Tank load for surcharge and moving loads3382026-09-14
Sign in to ask