Skip to content
AnsweredACulvertQ&A #2261992005-06-09 00:34 · Views 29

Culvert start-side angle is not applied

빠른 답변 부탁드립니다.

Answer2005-06-08 15:47

안녕하세요. 한길아이티입니다. 입력하신 암거 선형 길이가 암거 사각을 포함하여야 됩니다.암거 선형 길이를 충분히 늘려 주시면 됩니다. 감사합니다.

Follow-up2005-06-09 10:30

1. 설계환경입력에서 "설계조건(옹벽)" 하중계수를 바꾸고 싶은데 "적용"을 하면 원래값으로 돌아가네요 2. 옹벽형 날개벽에서 주철근과 배력철근, 전단철근의 철근 Dia.를 수동 입력하고 , "모든 암거 동일 적용"을 눌러주면 모든 값이 원상복귀 됩니다. 아주 돌아버려요~ 부탁드립니다~

Answer2005-06-09 13:49

안녕하세요. 한길아이티입니다. 수정후 패치에 적용하겠습니다. 감사합니다.

More in this list

StatusProductNo.TitleViewsDate
AnsweredACulvert#268543Pile calculation report3292026-09-28
AnsweredACulvert#268536Setting section changes in culvert1742026-09-28
AnsweredACulvert#268524Design check not performed at wall center2172026-09-27
AnsweredACulvert#268523Applying moving vehicle loads2382026-09-27
AnsweredACulvert#268522Question about pile layout2612026-09-23
AnsweredACulvert#268521Question about features1302026-09-23
AnsweredACulvert#268510Question about joint check in Excel report output1852026-09-22
AnsweredACulvert#268499Error in STM analysis of corner region1442026-09-22
AnsweredACulvert#268471Launching the culvert program592026-09-18
AnsweredACulvert#268442All lines are displayed as dashed lines, what should I do?1402026-09-17
AnsweredACulvert#268429Question about U-type underpass1262026-09-17
AnsweredACulvert#268424Load position when applying railway loads to an underpass2372026-09-17
AnsweredACulvert#268417Changing girder dimensions1522026-09-17
AnsweredACulvert#268396Incorrect section check location for horizontal rebar1832026-09-16
AnsweredACulvert#268376Question about segment settings for U-type retaining wall1932026-09-15
AnsweredACulvert#268343Question about culvert drawing output1282026-09-15
AnsweredACulvert#268337Inquiry about checking retaining-wall-type wing walls3062026-09-14
AnsweredACulvert#268330About drawing output1532026-09-14
AnsweredACulvert#268318Some blocks not displayed1402026-09-14
AnsweredACulvert#268317Tank load for surcharge and moving loads3402026-09-14
Sign in to ask