Skip to content
AnsweredACulvertQ&A #2258262005-02-01 02:33 · Views 79

Main rebar assembly drawing

주철근조립도가 치수선이 그려지지가 않습니다. 그리고 입력창의 값과는 틀린 값이 들어가 있습니다. 세개의 단면중 anchor(122+5)단면을 보세요.

Answer

안녕하세요. 한길아이티입니다. 수정을 완료하였습니다.금일 날자 버젼으로 패치를 하시면 되며,또한 입력된 파일에서 하부 상면 2단철근 입력방식이 잘못되어 파일도 같이 수정하여 올립니다.참조 하시기 바랍니다. 감사합니다. 안녕하세요. 한길아이티입니다. 치수 오류를 확인하였으며,현재 수정 작업을 진행하고 있습니다.수정 및 검토까지 다소 시간이 소요될듯 하며, 내일([개인정보])까지는 완료하여 패치에 반영토록 하겠습니다. 감사합니다.

More in this list

StatusProductNo.TitleViewsDate
AnsweredACulvert#268543Pile calculation report3292026-09-28
AnsweredACulvert#268536Setting section changes in culvert1742026-09-28
AnsweredACulvert#268524Design check not performed at wall center2172026-09-27
AnsweredACulvert#268523Applying moving vehicle loads2392026-09-27
AnsweredACulvert#268522Question about pile layout2622026-09-23
AnsweredACulvert#268521Question about features1302026-09-23
AnsweredACulvert#268510Question about joint check in Excel report output1852026-09-22
AnsweredACulvert#268499Error in STM analysis of corner region1442026-09-22
AnsweredACulvert#268471Launching the culvert program592026-09-18
AnsweredACulvert#268442All lines are displayed as dashed lines, what should I do?1402026-09-17
AnsweredACulvert#268429Question about U-type underpass1262026-09-17
AnsweredACulvert#268424Load position when applying railway loads to an underpass2372026-09-17
AnsweredACulvert#268417Changing girder dimensions1522026-09-17
AnsweredACulvert#268396Incorrect section check location for horizontal rebar1842026-09-16
AnsweredACulvert#268376Question about segment settings for U-type retaining wall1942026-09-15
AnsweredACulvert#268343Question about culvert drawing output1292026-09-15
AnsweredACulvert#268337Inquiry about checking retaining-wall-type wing walls3062026-09-14
AnsweredACulvert#268330About drawing output1542026-09-14
AnsweredACulvert#268318Some blocks not displayed1412026-09-14
AnsweredACulvert#268317Tank load for surcharge and moving loads3422026-09-14
Sign in to ask