Skip to content
AnsweredACulvertQ&A #2257312005-01-11 10:06 · Views 110

Internal application error message appears

옹벽형 날개벽 배근 시트를 넘어가지 못합니다. 내부 응용프로그램 오류라고 뜨네여~ 검토 부탁드립니다.

Answer

안녕하세요. 한길아이티입니다. 보내주신 파일을 확인해보면 날개벽 상세입력에서 정면도 EL 값이 잘못 들어가 있어서 생기는 오류입니다. EL 값은 mm로 받게끔 되어 있습니다. 시작 점 EL값과 구간 끝 EL 값이 너무 큰 차이가 나서 배근시 생기는 오류입니다. EL값을 수정하시면 날개벽 배근 시트에서 오류가 발생하지 않습니다. 추후 이러한 경우에도 경고창이나 오류가 뜨지 않게끔 수정하도록 하겠습니다. 감사합니다.

More in this list

StatusProductNo.TitleViewsDate
AnsweredACulvert#268543Pile calculation report3292026-09-28
AnsweredACulvert#268536Setting section changes in culvert1742026-09-28
AnsweredACulvert#268524Design check not performed at wall center2172026-09-27
AnsweredACulvert#268523Applying moving vehicle loads2392026-09-27
AnsweredACulvert#268522Question about pile layout2622026-09-23
AnsweredACulvert#268521Question about features1302026-09-23
AnsweredACulvert#268510Question about joint check in Excel report output1852026-09-22
AnsweredACulvert#268499Error in STM analysis of corner region1442026-09-22
AnsweredACulvert#268471Launching the culvert program592026-09-18
AnsweredACulvert#268442All lines are displayed as dashed lines, what should I do?1402026-09-17
AnsweredACulvert#268429Question about U-type underpass1262026-09-17
AnsweredACulvert#268424Load position when applying railway loads to an underpass2372026-09-17
AnsweredACulvert#268417Changing girder dimensions1522026-09-17
AnsweredACulvert#268396Incorrect section check location for horizontal rebar1842026-09-16
AnsweredACulvert#268376Question about segment settings for U-type retaining wall1942026-09-15
AnsweredACulvert#268343Question about culvert drawing output1292026-09-15
AnsweredACulvert#268337Inquiry about checking retaining-wall-type wing walls3062026-09-14
AnsweredACulvert#268330About drawing output1542026-09-14
AnsweredACulvert#268318Some blocks not displayed1412026-09-14
AnsweredACulvert#268317Tank load for surcharge and moving loads3422026-09-14
Sign in to ask