Skip to content
AnsweredACulvertQ&A #2257172005-01-06 05:50 · Views 58

Please recheck retaining wall rebar numbers

금일자 자동 패치를 적용한 후 말씀하신대로 입력을 하였으나 단면도(주철근 조립도)에서는 철근 번호가 올바르게 나타 납니다. 그런데 철근 입력 항목에서 아래부분의 배근도-벽체, 배근도-저판 항목을 체크한후 확대하여 보면 그 이전의 잘못된 철근 번호가 그대로 적용 됩니다. 다시 이것을 선택하지 않고 단면만 나타낼 경우에는 또 올바르게 표시 되고요~ 물론 도면 출력을 하여도 잘못된 철근번호가 그대로 출력 됩니다. 검토 부탁드리겠습니다.

Answer

안녕하세요. 한길아이티입니다. 네 1월5일자 패치는 오후 10시 30분에 업데이트 하였습니다. 패치를 받으시면 업데이트가 됩니다. 감사합니다.

More in this list

StatusProductNo.TitleViewsDate
AnsweredACulvert#268543Pile calculation report3292026-09-28
AnsweredACulvert#268536Setting section changes in culvert1742026-09-28
AnsweredACulvert#268524Design check not performed at wall center2172026-09-27
AnsweredACulvert#268523Applying moving vehicle loads2392026-09-27
AnsweredACulvert#268522Question about pile layout2622026-09-23
AnsweredACulvert#268521Question about features1302026-09-23
AnsweredACulvert#268510Question about joint check in Excel report output1852026-09-22
AnsweredACulvert#268499Error in STM analysis of corner region1442026-09-22
AnsweredACulvert#268471Launching the culvert program592026-09-18
AnsweredACulvert#268442All lines are displayed as dashed lines, what should I do?1402026-09-17
AnsweredACulvert#268429Question about U-type underpass1262026-09-17
AnsweredACulvert#268424Load position when applying railway loads to an underpass2372026-09-17
AnsweredACulvert#268417Changing girder dimensions1522026-09-17
AnsweredACulvert#268396Incorrect section check location for horizontal rebar1842026-09-16
AnsweredACulvert#268376Question about segment settings for U-type retaining wall1942026-09-15
AnsweredACulvert#268343Question about culvert drawing output1292026-09-15
AnsweredACulvert#268337Inquiry about checking retaining-wall-type wing walls3062026-09-14
AnsweredACulvert#268330About drawing output1542026-09-14
AnsweredACulvert#268318Some blocks not displayed1412026-09-14
AnsweredACulvert#268317Tank load for surcharge and moving loads3422026-09-14
Sign in to ask