Skip to content
AnsweredACulvertQ&A #2254402004-10-25 13:31 · Views 64

About rebar at wall center

안녕하세요. 오늘 업그레이드를 하고 암거계산을 했는데 벽체 중앙부 단면검토에서 입력된 철근량이 제대로 계산되지 않는것 같습니다. 제가 입력한 것은 D22@125 간격인데 계산은 D19@125 간격으로 되는것 같습니다. 현재 구조계산서를 보면 단면검토는 D19로 되어있는데 주철근 조립도는 D22@125로 되어 있습니다. 빠른 검토 부탁 드립니다.

Answer

안녕하세요. 한길아이티입니다. 보내주신 암거는 슬래브의 길이가 길고 벽체가 낮아서 벽체쪽에 부모멘트만이 작용하고 있습니다. 따라서 철근의 검토는 벽체 내측철근을 검토하는 것이 아니라 벽체의 부모멘트에 저항하는 벽체 외측철근으로 검토하고 있습니다. 자세한 사항은 전화로 말씀드렸습니다. 감사합니다.

More in this list

StatusProductNo.TitleViewsDate
AnsweredACulvert#268543Pile calculation report3292026-09-28
AnsweredACulvert#268536Setting section changes in culvert1742026-09-28
AnsweredACulvert#268524Design check not performed at wall center2172026-09-27
AnsweredACulvert#268523Applying moving vehicle loads2392026-09-27
AnsweredACulvert#268522Question about pile layout2622026-09-23
AnsweredACulvert#268521Question about features1302026-09-23
AnsweredACulvert#268510Question about joint check in Excel report output1852026-09-22
AnsweredACulvert#268499Error in STM analysis of corner region1442026-09-22
AnsweredACulvert#268471Launching the culvert program592026-09-18
AnsweredACulvert#268442All lines are displayed as dashed lines, what should I do?1402026-09-17
AnsweredACulvert#268429Question about U-type underpass1262026-09-17
AnsweredACulvert#268424Load position when applying railway loads to an underpass2372026-09-17
AnsweredACulvert#268417Changing girder dimensions1522026-09-17
AnsweredACulvert#268396Incorrect section check location for horizontal rebar1842026-09-16
AnsweredACulvert#268376Question about segment settings for U-type retaining wall1942026-09-15
AnsweredACulvert#268343Question about culvert drawing output1292026-09-15
AnsweredACulvert#268337Inquiry about checking retaining-wall-type wing walls3062026-09-14
AnsweredACulvert#268330About drawing output1542026-09-14
AnsweredACulvert#268318Some blocks not displayed1412026-09-14
AnsweredACulvert#268317Tank load for surcharge and moving loads3422026-09-14
Sign in to ask