Skip to content
AnsweredACulvertQ&A #2253912004-10-13 14:04 · Views 59

Sliding check of retaining-wall-type wing wall

옹벽식날개벽 활동검토시 B1,B2,B3가 제원에 입력한대로 되지 않아서 NG가 나옵니다. 그리고 건교부표준도에서는 콘크리트와 흙의 마찰계수를 제시하고 있고, 혹은 지반의 내부마찰각이 제시되므로 기초지반의 N치에서 기초지반의 내부마찰각을 추정할 필요없이 직접입력이 가능해야 할 것이며 기초잡석이 없을시 마찰각에 2/3를 곱한값을 취하는 것도 수정되어야 할 것 같습니다. (직접입력가능요구항목: 마찰계수 또는 기초지반의 내부마찰각)

Answer

안녕하세요. 한길아이티입니다. 전화상으로 말씀드렸습니다. 감사합니다.

More in this list

StatusProductNo.TitleViewsDate
AnsweredACulvert#268543Pile calculation report3292026-09-28
AnsweredACulvert#268536Setting section changes in culvert1742026-09-28
AnsweredACulvert#268524Design check not performed at wall center2172026-09-27
AnsweredACulvert#268523Applying moving vehicle loads2392026-09-27
AnsweredACulvert#268522Question about pile layout2632026-09-23
AnsweredACulvert#268521Question about features1302026-09-23
AnsweredACulvert#268510Question about joint check in Excel report output1852026-09-22
AnsweredACulvert#268499Error in STM analysis of corner region1442026-09-22
AnsweredACulvert#268471Launching the culvert program592026-09-18
AnsweredACulvert#268442All lines are displayed as dashed lines, what should I do?1402026-09-17
AnsweredACulvert#268429Question about U-type underpass1262026-09-17
AnsweredACulvert#268424Load position when applying railway loads to an underpass2372026-09-17
AnsweredACulvert#268417Changing girder dimensions1522026-09-17
AnsweredACulvert#268396Incorrect section check location for horizontal rebar1842026-09-16
AnsweredACulvert#268376Question about segment settings for U-type retaining wall1942026-09-15
AnsweredACulvert#268343Question about culvert drawing output1292026-09-15
AnsweredACulvert#268337Inquiry about checking retaining-wall-type wing walls3062026-09-14
AnsweredACulvert#268330About drawing output1542026-09-14
AnsweredACulvert#268318Some blocks not displayed1412026-09-14
AnsweredACulvert#268317Tank load for surcharge and moving loads3422026-09-14
Sign in to ask