Skip to content
AnsweredACulvertQ&A #2252022004-08-27 19:41 · Views 74

Reinforcement drawing generated incorrectly

슬래브 배근도 생성이 구조물 외곽선과 맞지 않습니다. 하부슬래브 헌치를 사각형으로 형성하면 헌치 철근배치가 주철근 조립도에서 이상하게 나오네요 한번 봐 주십시오.

Answer

안녕하세요. 한길아이티입니다. 1.배근도의 형상이 이상하게 나오는 현상은 선형이 제대로 적용되지 않아서 발생하는 현상인듯 합니다. 검토후 수정하여 패치하겠습니다. 현재는 단면도 제원입력의 중심선 이격거리를 0으로 입력하시면 제대로 출력되고 있습니다. 2.헌치철근이 주철근 조립도에서 이상하게 나오는 현상은 입력오류입니다. H5와 H7의 입력은 삼각형헌치의 제원입력사항입니다. 사각헌치로 입력하시려면 H5 ==> H6 , H7 ==> H8 로 입력사항을 수정하여 입력하시면 됩니다. 감사합니다.

More in this list

StatusProductNo.TitleViewsDate
AnsweredACulvert#268543Pile calculation report3292026-09-28
AnsweredACulvert#268536Setting section changes in culvert1742026-09-28
AnsweredACulvert#268524Design check not performed at wall center2172026-09-27
AnsweredACulvert#268523Applying moving vehicle loads2392026-09-27
AnsweredACulvert#268522Question about pile layout2632026-09-23
AnsweredACulvert#268521Question about features1302026-09-23
AnsweredACulvert#268510Question about joint check in Excel report output1852026-09-22
AnsweredACulvert#268499Error in STM analysis of corner region1442026-09-22
AnsweredACulvert#268471Launching the culvert program592026-09-18
AnsweredACulvert#268442All lines are displayed as dashed lines, what should I do?1402026-09-17
AnsweredACulvert#268429Question about U-type underpass1262026-09-17
AnsweredACulvert#268424Load position when applying railway loads to an underpass2372026-09-17
AnsweredACulvert#268417Changing girder dimensions1522026-09-17
AnsweredACulvert#268396Incorrect section check location for horizontal rebar1842026-09-16
AnsweredACulvert#268376Question about segment settings for U-type retaining wall1942026-09-15
AnsweredACulvert#268343Question about culvert drawing output1292026-09-15
AnsweredACulvert#268337Inquiry about checking retaining-wall-type wing walls3062026-09-14
AnsweredACulvert#268330About drawing output1542026-09-14
AnsweredACulvert#268318Some blocks not displayed1412026-09-14
AnsweredACulvert#268317Tank load for surcharge and moving loads3422026-09-14
Sign in to ask