Skip to content
AnsweredACulvertQ&A #2251662004-08-17 11:12 · Views 50

End-side cutoff wall rebar details still not generated after update

오늘 오전에 업뎃하였습니다. 종점부 차수벽의 제원을 입력하는 기능은 추가되어 재료표데이터는 생성되는데 도면엔 단면도, 철근상세도, 재료표가 여전히 미생성되고 있습니다. 확인부탁드립니다..수고하세요..

Answer

안녕하세요. 한길아이티입니다. 배근도(1)에서 차수벽상세가 출력되지않는 오류는 수정하였습니다. 현재 철근수량 및 재료표의 철근상세등은 철근제원에서 [철근제원설정]-"암거상세부"의 권고안을 하시면 이상이 없이 설정되고 있습닏. 수정내용은 금일자 패치에 적용하도록 하겠습니다. 감사합니다.

More in this list

StatusProductNo.TitleViewsDate
AnsweredACulvert#268543Pile calculation report3292026-09-28
AnsweredACulvert#268536Setting section changes in culvert1742026-09-28
AnsweredACulvert#268524Design check not performed at wall center2172026-09-27
AnsweredACulvert#268523Applying moving vehicle loads2392026-09-27
AnsweredACulvert#268522Question about pile layout2632026-09-23
AnsweredACulvert#268521Question about features1302026-09-23
AnsweredACulvert#268510Question about joint check in Excel report output1852026-09-22
AnsweredACulvert#268499Error in STM analysis of corner region1442026-09-22
AnsweredACulvert#268471Launching the culvert program592026-09-18
AnsweredACulvert#268442All lines are displayed as dashed lines, what should I do?1402026-09-17
AnsweredACulvert#268429Question about U-type underpass1262026-09-17
AnsweredACulvert#268424Load position when applying railway loads to an underpass2372026-09-17
AnsweredACulvert#268417Changing girder dimensions1522026-09-17
AnsweredACulvert#268396Incorrect section check location for horizontal rebar1842026-09-16
AnsweredACulvert#268376Question about segment settings for U-type retaining wall1942026-09-15
AnsweredACulvert#268343Question about culvert drawing output1292026-09-15
AnsweredACulvert#268337Inquiry about checking retaining-wall-type wing walls3062026-09-14
AnsweredACulvert#268330About drawing output1542026-09-14
AnsweredACulvert#268318Some blocks not displayed1412026-09-14
AnsweredACulvert#268317Tank load for surcharge and moving loads3422026-09-14
Sign in to ask