Skip to content
AnsweredACulvertQ&A #2250372004-07-19 23:35 · Views 65

Reinforcement drawing and quantity errors

수고하십니다. 주철근 조립도 배근오류와함께 철근수량이 넘 과다한것 같습니다. 확인 부탁합니다.

Answer

안녕하세요. 한길아이티입니다. 감사합니다. [기초자료]-[철근단위중량 및 단면적]의 값이 잘못된 값으로 설정이 되어 있습니다. 권고안을 하신후 확인하시면 이상이 없습니다. 주철근입력에서 잘못 표현된 부분의 철근입력위치에서 "적용"을 하시면 철근이 다시 설정이 됩니다. 그리고 배근도(3)의 출력오류는 수정하였습니다. 날개벽배근도의 경우는 도면환경설정에서 테이블줄수를 입력하시면 됩니다. 수정사항은 패치를 적용하신 후 확인하시면 됩니다.

More in this list

StatusProductNo.TitleViewsDate
AnsweredACulvert#268543Pile calculation report3292026-09-28
AnsweredACulvert#268536Setting section changes in culvert1742026-09-28
AnsweredACulvert#268524Design check not performed at wall center2172026-09-27
AnsweredACulvert#268523Applying moving vehicle loads2392026-09-27
AnsweredACulvert#268522Question about pile layout2642026-09-23
AnsweredACulvert#268521Question about features1302026-09-23
AnsweredACulvert#268510Question about joint check in Excel report output1852026-09-22
AnsweredACulvert#268499Error in STM analysis of corner region1442026-09-22
AnsweredACulvert#268471Launching the culvert program592026-09-18
AnsweredACulvert#268442All lines are displayed as dashed lines, what should I do?1402026-09-17
AnsweredACulvert#268429Question about U-type underpass1262026-09-17
AnsweredACulvert#268424Load position when applying railway loads to an underpass2372026-09-17
AnsweredACulvert#268417Changing girder dimensions1522026-09-17
AnsweredACulvert#268396Incorrect section check location for horizontal rebar1842026-09-16
AnsweredACulvert#268376Question about segment settings for U-type retaining wall1942026-09-15
AnsweredACulvert#268343Question about culvert drawing output1292026-09-15
AnsweredACulvert#268337Inquiry about checking retaining-wall-type wing walls3062026-09-14
AnsweredACulvert#268330About drawing output1542026-09-14
AnsweredACulvert#268318Some blocks not displayed1412026-09-14
AnsweredACulvert#268317Tank load for surcharge and moving loads3422026-09-14
Sign in to ask