Skip to content
AnsweredACulvertQ&A #2248102004-04-28 11:10 · Views 201

Please check the moment

안녕하세요.. 5번째 수로암거에서 상부슬래브에 나오는 모멘트값이 좌우가 틀립니다.. 제가 편토압을 준것도 아니고 확인해보니깐 연직하중에서 값이 틀리더군요.. sap에서는 소숫점2자리까지 나와서 확인이 안되는데 소숫점3자리에서 틀리더군요(암거프로그램상의 모델링에서 확인해보니깐) 한번 확인해주세요...

Answer

안녕하세요. 한길아이티입니다. 확인결과 2단주철근 배근시 철근의 중립축에 따라 d값 산정시 약간의 오류가 있어 절점위치의 변경에 따라 좌우측의 모멘트가 틀리게 출력되었습니다. 다음 패치에 수정하여 반영하겠습니다. 감사합니다.

More in this list

StatusProductNo.TitleViewsDate
AnsweredACulvert#268543Pile calculation report3292026-09-28
AnsweredACulvert#268536Setting section changes in culvert1742026-09-28
AnsweredACulvert#268524Design check not performed at wall center2172026-09-27
AnsweredACulvert#268523Applying moving vehicle loads2392026-09-27
AnsweredACulvert#268522Question about pile layout2662026-09-23
AnsweredACulvert#268521Question about features1302026-09-23
AnsweredACulvert#268510Question about joint check in Excel report output1852026-09-22
AnsweredACulvert#268499Error in STM analysis of corner region1442026-09-22
AnsweredACulvert#268471Launching the culvert program592026-09-18
AnsweredACulvert#268442All lines are displayed as dashed lines, what should I do?1402026-09-17
AnsweredACulvert#268429Question about U-type underpass1262026-09-17
AnsweredACulvert#268424Load position when applying railway loads to an underpass2372026-09-17
AnsweredACulvert#268417Changing girder dimensions1522026-09-17
AnsweredACulvert#268396Incorrect section check location for horizontal rebar1842026-09-16
AnsweredACulvert#268376Question about segment settings for U-type retaining wall1942026-09-15
AnsweredACulvert#268343Question about culvert drawing output1292026-09-15
AnsweredACulvert#268337Inquiry about checking retaining-wall-type wing walls3062026-09-14
AnsweredACulvert#268330About drawing output1542026-09-14
AnsweredACulvert#268318Some blocks not displayed1412026-09-14
AnsweredACulvert#268317Tank load for surcharge and moving loads3422026-09-14
Sign in to ask